Dust-free sandblasting machine carbide sandblasting machine

1. The workpiece is conveyed by triangular belt, and the belt speed can be adjusted by frequency conversion to meet the requirements of sandblasting process;

2. The Angle of each spray gun can be adjusted freely, the gun rack can swing automatically by frequency conversion, and can be fixed point sandblasting, wide application range, strong flexibility;

3. Adopting advanced upper cyclone separation system, the dust separation effect is good, the sandblasting efficiency is high, and the spray loss is effectively reduced

4. PLC programming controller electric advanced control system, high degree of automation, good stability, low failure rate;

5. The nozzle is made of special high wear-resisting boron carbide material with long service life;

6. Bag dust removal system of crystal sandblasting machine, good dust removal and ventilation effect; (Pulse filter element dust removal can also be selected);

7. The abrasive recovery adopts the combination of spiral conveying and pneumatic recovery, with good recovery stability;

8. Can be customized according to customer's product requirements. Measurement and manufacturing capacity to undertake non-standard sandblasting machine series development.

Processing efficiency: according to customer's requirements for workpiece materials and processing technology. It depends on the actual processing of the workpiece.

Pressure-type sandblasting machine processing method overview:

1. According to the width of the workpiece to be processed, the quantity of the spray gun is determined to meet the requirements of sandblasting of different specifications of the workpiece.

2. Turn on the power switch, the lighting lamp is on, and turn on the motor of the exhaust and dust removal system; Add qualified sand.

3. Clamp the workpiece on the fixture and place it on the conveyor belt in turn.

4. The workpiece passes through the sandblasting chamber at a uniform speed along with the conveyor belt, and the gun swings sandblasting reciprocately under the drive of the motor.

5. The processed workpiece is blown through the blowing chamber, and the air gun blows down the residual sand on the surface of the workpiece, and the worker takes down the workpiece with good sandblasting.

6. There should be more than 2 operators.