Common stainless steel sandblasting process introduction:

Stainless steel sandblasting technology refers to the use of abrasive materials, through sandblasting technology processing stainless steel surface, beautify the processing effect of the surface of stainless steel.

There are two kinds of stainless steel sand blasting process.

Dry sandblasting is a common and multi-purpose sandblasting technology. It has the advantages of high processing efficiency, low sand blasting cost and uniform surface of stainless steel after processing. However, if the processing of stainless steel requirements are particularly high, the need for surface treatment after the completion of sandblasting.

Wet sandblasting, wet sandblasting is the high requirements of the stainless steel surface sandblasting technology, wet sandblasting stainless steel surface after the atomization effect, the surface is fine and consistent, wet sandblasting processing is completed, the need to quickly clean the surface water stains, processing efficiency is slower than dry sandblasting, equipment cost is higher than dry sandblasting.

How to reduce the loss of sand blasting machine?

Saving abrasive material for a sand blaster is closely related to the success of the manufacturer. So how to save abrasive? It is mainly reflected in five aspects.

First, the pressure is very important, directly lead to the abrasive loss of sandblasting machine.

In order to achieve fast efficiency and low abrasive loss, it is necessary to understand the user's product materials and detailed accurate data.

Two, dust collector.

The sandblasting machine is adjusted to the exact position before use. Clean the vacuum cleaner filter cartridge in time, immediately remove the waste sand inside, minimize the amount of abrasive.

Three, spray gun.

Before using the sandblasting machine, check whether there is wear in the spray gun and check the sand nozzle. Nozzles and other wear, must be replaced immediately, indirect to avoid wear.

Four, sand pipe.

Whether the sand pipe is straight is a necessary condition to check the blasting machine before work. If bent, it will definitely waste the amount of scrub.

Five, separator.

This is an important part of saving abrasive, before choosing sandblasting machine, should first accurately tell the type of abrasive manufacturers, so that manufacturers in the design can be well combined with the standard you need, do accurate control of the pressure of sandblasting machine. Abrasives will naturally help reduce usage.