Sand blasting machine operation needs to pay attention to the details.

Sand blasting technology is a process of cleaning and coarsening the surface of matrix by the impact of high speed sand flow. The compressed air is used as the power to form a high-speed jet beam. The jet material is sprayed to the workpiece surface at a high speed to change the appearance and shape of the workpiece surface and grind the impact and cutting effect of the material on the workpiece surface. Due to the abrasive effect on impact on the surface of the workpiece and cutting, make get a certain cleanness and roughness of workpiece surface, improved the mechanical properties of the workpiece surface, improve the fatigue resistance of the workpiece, enhance the adhesion and coating, extend the durability of the coating, is conducive to peace in the coating decoration, in addition to the surface of the impurity, noise and oxide layer

Details should be paid attention to in the operation of sandblasting machine:

On the other hand, the circulation sandblasting machine sand amount is less, the sand will not come. The sand material consumption of the sand storage barrel, close the air, and slowly add the corresponding sand material.

Two, spray gun has the possibility of blockage: stop breathing, the nozzle, see whether there is a foreign body, pipe sandblasting machine sometimes clean foreign body, but also to see whether the sand is dry, sand is too wet and blocked, compressed air must be dry.

Three, sandblasting pipe blockage: pipe blockage stolen goods, stop breathing after closing breathing, the nozzle is removed first, and then open the sandblasting machine, with the compressor of high pressure gas blowing out the foreign body, if there is no effect, please remove the pipe cleaning or replacement.

Four, sand blasting grinding material wet combined with sand, the spray gun nozzle is clean, sand blasting grinding material poured out, dry with screen filtering can be.

Five. A large amount of water is produced by the compressed air of the compressor with the sandblasting unit, which will not only cause the moisture of the sand material, but also cause the moisture of the sandblasting pipe wall to adhere to the sand material, and slowly clog the pipe. Therefore, this situation needs to be avoided and a dryer is equipped.