Many customers in the whole process of sandblasting process, are will encounter sandblasting treatment asymmetry of doubt, what is the cause of it?

1. When the speed of sandblasting machine is relatively slow and the speed is fast, the sand emitted by the two sandblasting machine factory in the enterprise time is the same, but the total area of sand dissemination in front of a smaller, then large, because as much sand is scattered on the surface of the total area of different samples, it is bound to show the phenomenon of more dense difference.

When a gas shrinker is used to spray paint many times, the standard pressure is difficult to stabilize, when the standard pressure is high, suction and sandblasting is more, when the pressure is low, in turn, that suction and sandblasting is less, sandblasting is more, sandblasting is more, sandblasting is more, sandblasting is less.

3. When the sandblasting machine is near the surface of the products, the operation scale of the spray is small, but by comparison, it looks closer. When the spray gun is far from the surface of the product, the spray of sand is still so much, but the total area of the spray is expanded, and it will look scarce at this time.

Finally, the bag dust remover of the sandblasting machine is introduced in detail. It is an internal structure of the sandblasting machine. It is likely that many people do not grasp it very much.

Sandblasting machine cloth bag dust collector is based on gas producer tighten gas method remove filter material (cloth bag or filter cartridge) on adhesion of dust, according to the size of the dust removal equipment is likely to have several pulse valve, by single pulse control meter or PLC control, each time a group of pulse valve open to remove it by which a spreading dust bag or filter cartridge, While other cloth bags or cartridge all normal work, after a period of time after the next set of pulse valve opened, carding under a few, always so the circulation system down.