Operation specification of sandblasting machine:

A, blasting machine before the start of the inspection, preparation:

Two, power on operation:

1. Turn on the power switch, the lighting lamp is on, and the separation motor starts.

2. Open the working cabin and put the workpiece to be processed on the rotary table in the engine room. The quantity is different.

3. Gently tread the switch, compressed air enters the spray gun, and the grinding material is sprayed according to the set amount. It is introduced into the spray gun from the bottom of the separator storage tank and sprayed to the surface of the processed workpiece at high speed under the action of compressed air.

4. In the process of sandblasting, on the one hand, it is necessary to keep the spray gun and the workpiece with appropriate spray distance and Angle, on the other hand, it is necessary to make the relative movement between the spray gun and the workpiece, so that the workpiece surface is uniformly processed by abrasive jet, until the satisfactory results are achieved.

5. After finishing the processing, the foot must be removed from the foot switch. After the spray gun stops spraying abrasive materials, open the studio door and take out the workpiece.

6. Do not turn off the separator and lighting power if you need to continue processing the workpiece.

Three, stop the operation:

After the work is finished, the separator and lighting power must be turned off.

IV. Maintenance and maintenance:

1. The manufacturer shall clean the dust every 4-8 hours, turn off the power switch, press the vibration valve for 1-2 minutes, make the dust bag vibrate to drop the dust, open the cover at the bottom of the dust box, and fill the dust with the container. 2. Maintenance once a month, vacuum sandblasting machine to replace the vulnerable parts (rubber gloves, sandblasting pipe).

Five, safety precautions:

1. It is forbidden to adjust the parameters of the machine without authorization during use. Violators will be severely punished. 2. In the process of operation, it is forbidden to spray to people through the sandblasting machine to avoid personal safety accidents. 3. During the operation, the operator recorded once falling asleep.